Bottle Moulds, Machine Matching and Auxiliary Equipment
A bottle mould is part of the production process, not a separate accessory. Bottle geometry, resin, neck finish, cavities, machine configuration and operating conditions must be evaluated together.
LIANXIN provides supporting moulds for its bottle molding projects and coordinates mould requirements with the selected IBM-H, IBM-E, ISBM or IBBM process. The customer catalogue highlights high-precision core-rod and thread design.
Information needed for mould review
- 2D or 3D bottle drawing
- Physical bottle or reference sample
- Bottle volume, weight and dimensions
- Neck finish, cap or pump interface
- Approved resin and shrinkage information
- Required cavities and output
- Surface, transparency and parting-line expectations
- Dimension and leak-test criteria
- Intended contents and end-use validation requirements
Typical project stages
1. Bottle and process feasibility review
2. Machine family and mould arrangement confirmation
3. Drawing and interface confirmation
4. Mould manufacturing
5. Machine-mounted trial
6. Bottle inspection against agreed criteria
7. Process adjustment and record
8. Acceptance and commissioning support
The controlled project specification should identify the approved drawing version, resin, cavity count, key dimensions, visual criteria, trial conditions and acceptance method. If the bottle or material changes, mould and process suitability should be reviewed again.
A mould trial does not by itself approve a package for food, pharmaceutical, chemical or other regulated use. Read the application guidance or send your bottle data.
Catalogue-listed auxiliary equipment
- Auto loader
- Doser
- Crusher
- Chiller
- Air compressor
- Mould temperature controller
- Three-in-one dehumidifying dryer
Auxiliary sizing depends on resin, machine, mould, cycle, ambient conditions and site utilities. The final utility and interface schedule belongs in the controlled project specification.